MDS-1000
The basic system is equipped with the most important features and convinces by its excellent usability.
CHALLENGES regarding blast hole drillings
Machine alignment
Aligning the machine is an additional difficulty in the slope alignment of the drilling arm.
PARALLEL DRILL HOLES
It’s difficult to drill parallel holes, only with marks on the ground.
Exact depth
It’s nearly impossible to drill all holes to the same depth without any measuring system.
High operation costs
The manual measuring causes high operating expenses and is also a huge time factor.
Safety
If the boreholes are drilled in the wrong position, explosions may result in rockfall and a dirty break-off edge.
Drill alignment
It’s difficult to drill all the holes in the same angle.
Solutions
01
Drilling system for precise blast hole borings
MDS-1000
With MOBA’s MDS-1000 drilling system, you can prepare your blast with precisely measured, uniform drill holes and immediately increase your cost efficiency. Save yourself time-consuming manual measurements and drill absolutely parallel holes of the same depth and angle in just a few simple steps with the assistance system.
MDS-1000 System components
Operating Panel
Intuitive and easy to use, it gives you all the important information such as depth, quantity of bars and ACTUAL and TARGET inclination of the boom.
DEPTH GAUGE
Precise measurement of the bore depth with the rotary encoder. It has a measuring range of 360° and a PWM/analog interface.
INCLINATION SENSOR
2-axis tilt sensor with a measuring range of ±60°. The zero point adjustment is done via an infrared interface.
02
High-end drilling system with programmable graphic display
MDS-2000
The high-end MDS-2000 drilling system from MOBA allows you to prepare your blast with precisely measured, uniform drill holes and increase your cost efficiency immediately. Save time-consuming, manual measurements and drill parallel holes of the same depth and angle in just a few steps using the assistance system. Thanks to extraordinary modularity, you can also benefit from cost- and time-efficient upgrades from a varied selection of additional components.
MDS-2000 System components
Graphic display
Self-programmable graphic display with real-time data from all drilling-related data and machine and engine parameters.
INCLINATION SENSOR
2-axis tilt sensor with a measuring range of ±60°. The zero point adjustment is done via an infrared interface.
DEPTH GAUGE
Precise measurement of the bore depth with the rotary encoder. It has a measuring range of 360° and a PWM/analog interface.
Boom Sensor
Exact measurement of the mast's cross slope. It has a measuring range of 360° as well as a PWM/analog interface.
Controller
It processes and calculates all system data in real time and controls all connected components.
Direction Finder
Detects the direction in which the machine is moving in order to check its position. The direction finder is adjusted for reference.
GNSS Antenna
Precise positioning of the machine in the terrain and works with GNSS and GLONASS. The antenna replaces the direction finder.
Gateway CG-1
Use the telemetry module to send data on your boreholes and engine data such as oil pressure or acceleration directly from the machine to the office with perfect cloud integration.
